VK-AD-2140
Cast components
Aluminium gearbox housing
High-pressure die-cast housing, CNC machined and leak tested before shipment.
Product catalogue
Representative parts in four production groups. Each card shows material and process; the detail page adds a specification table and production steps. Ask for a quote with your drawing, whether the part resembles the catalogue or not.
01 Product group
Cast components
High-pressure aluminium die casting and grey-iron housings, heat treatment and machining included.
VK-PD-3310
VK-AD-2205
02 Product group
Precision machining
Tight-tolerance shafts, flanges and blocks on CNC lathes and 5-axis machining centres.
VK-TM-4120
Precision machining
Differential flange
Turned and milled flange from forged steel blank, case hardened.
VK-TM-4388
Precision machining
Axle shaft
Induction-hardened, ground axle shaft with splined end and bearing seats.
VK-TM-4510
Precision machining
Hydraulic valve block
Aluminium block with deep-hole and cross-drilled channels, delivered burr-free and washed.
03 Product group
Tooling and dies
Design, manufacture and maintenance of casting, injection and sheet-forming dies.
VK-KL-5102
Tooling and dies
Die-casting tool (HPDC)
Hot-work steel tool for aluminium high-pressure die casting; cooling channels placed by simulation.
VK-KL-5230
04 Product group
Assembly groups
Sub-assemblies built from our parts: press fitting, welding and torque-controlled assembly.
VK-MG-6010
Assembly groups
Suspension arm assembly
Forged arm completed with bushings and ball joint; press-fit force recorded per unit.
VK-MG-6240
A part that is not in the catalogue?
Send the drawing with volume and timing; we reply with a feasibility note and a quote.